Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E161312
  1. Remove the nut and remove the wiper arm and blade assembly.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

HINT:
Use the same procedure for both sides.



3. REMOVE FRONT FENDER TO COWL SIDE SEAL RH


    E161313
  1. Disengage the claw and remove the front fender to cowl side seal.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

HINT:
Use the same procedure for both sides.



5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E161315
  1. Remove the 2 clips.

  1. Remove the 6 claws and 8 guides and remove the cowl top ventilator louver sub-assembly.



6. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY


    E161316
  1. Disconnect the connector.

  1. Remove the nut.

  1. Remove the 4 bolts and wiper motor and link assembly.



7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E161317E01
  1. Using a screwdriver with its tip wrapped in protective tape, disconnect the rod of the wiper link assembly from the crank arm pivot of the front wiper motor, as shown in the illustration.



    E161319
  1. Put matchmarks on the crank arm and front wiper motor, as shown in the illustration.

  1. Remove the nut and remove the crank arm.



    E161320
  1. Remove the 3 bolts and remove the windshield wiper motor.