Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK STOP LIGHT CONTROL RELAY (BRK NO. 1, BRK NO. 2)
  1. Remove the 2 stop light control relays from the engine room relay block.



    C210886E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for BRK NO. 1 
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage not applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω
    for BRK NO. 2 
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage not applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.

  1. Install the 2 stop light control relays.