Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    E146587E02
  1. Check the power source circuit and ground circuit.

    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      1 (B) - 4 (E)
      Always
      11 to 14 V
      3 (IG) - 4 (E)
      Ignition switch ON
      11 to 14 V
      11 (+B) - 4 (E)
      Always
      11 to 14 V

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (E) - Body ground
      Always
      Below 1 Ω

  1. Check the output operation signal.

    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      2 (LL) - 4 (E)
      Hazard warning switch OFF
      Below 1 V
      Hazard warning switch ON
      9 V or higher (60 to 120 times per minute)
      6 (EL) - 4 (E)
      Headlight dimmer switch (TURN L) OFF
      9 V or higher
      Headlight dimmer switch (TURN L) ON
      Below 1 V
      7 (ER) - 4 (E)
      Headlight dimmer switch (TURN R) OFF
      9 V or higher
      Headlight dimmer switch (TURN R) ON
      Below 1 V
      8 (LR) - 4 (E)
      Hazard warning switch OFF
      Below 1 V
      Hazard warning switch ON
      9 V or higher (60 to 120 times per minute)
      12 (HAZ) - 4 (E)
      Hazard warning switch OFF
      9 V or higher
      Hazard warning switch ON
      Below 1 V