Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH
  1. Remove the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



2. REMOVE COWL SIDE TRIM BOARD RH
  1. Remove the cowl side trim board RH .

    HINT:
    Use the same procedures described for the LH side.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE 4WD CONTROL ECU


    C160016
  1. Disconnect the 2 4WD control ECU connectors.

  1. Remove the bolt and 4WD control ECU.