Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › 4WD CONTROL SWITCH

4WD CONTROL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL 4WD CONTROL SWITCH


    C159796
  1. Attach the 3 claws to install the switch.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and attach the wire harness clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. engage the 3 claws to install the hood lock lever



5. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



6. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



7. FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.