AIR SWITCHING VALVE > REMOVAL |
| 1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY |
Remove the exhaust manifold (Click here).
| 2. REMOVE INTAKE MANIFOLD |
Remove the intake manifold (Click here).
| 3. REMOVE FAN SHROUD |
Remove the fan shroud (Click here).
| 4. DISCONNECT NO. 1 WATER BY-PASS HOSE |
![]() |
Disconnect the No. 1 water by-pass hose from the water by-pass joint and water inlet housing.
| 5. DISCONNECT NO. 2 WATER BY-PASS HOSE |
Disconnect the No. 2 water by-pass hose from the water by-pass joint.
| 6. DISCONNECT WATER BY-PASS PIPE HOSE (w/ Trailer Towing System) |
![]() |
Remove the 3 bolts and disconnect the water by-pass pipe hose.
| 7. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
Remove the No. 2 cylinder head cover.
| 8. DISCONNECT FUEL TUBE CLAMP |
![]() |
Disconnect the fuel tube clamp from the bracket.
| 9. REMOVE NO. 1 ENGINE COVER |
![]() |
Remove the No. 1 engine cover.
| 10. REMOVE FRONT WATER BY-PASS JOINT |
Disconnect the engine coolant temperature sensor connector.
![]() |
Remove the 4 nuts, front water by-pass joint and 2 gaskets.
| 11. REMOVE AIR PIPE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 air injection system hose and No. 3 air injection system hose.
Disconnect the air switching valve connector.
Disconnect the air switching valve connector clamp holder.
Using a clip remover, detach the wire harness claw.
![]() |
Remove the 2 bolts and air pipe.
Disconnect the 2 No. 1 air hoses from the air switching valve assembly.
| 12. REMOVE AIR SWITCHING VALVE ASSEMBLY |
![]() |
Disconnect the knock sensor connector.
Remove the bolt and bracket.
Disconnect the 2 air switching valve connectors.
![]() |
Remove the 3 bolts and air switching valve assembly.
| 13. REMOVE NO. 2 AIR TUBE |
![]() |
Remove the 2 bolts, No. 2 air tube and gasket.
| 14. REMOVE NO. 3 AIR TUBE |
![]() |
Remove the 2 bolts, No. 3 air tube and gasket.