CLEARANCE SONAR MAIN SWITCH > INSPECTION |
| 1. INSPECT DRIVE MONITOR SWITCH |
Check the resistance.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 7 (IG) - 8 (SK) | Sonar switch off | 10 kΩ or higher |
| Sonar switch on | Below 1 Ω |
Inspect the illumination operation.
Connect the positive (+) lead of the battery to terminal 1 (ILL+) and the negative (-) lead to terminal 6 (ILL-), and then check that the illumination illuminates.