STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > ON-VEHICLE INSPECTION |
| 1. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
![]() |
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 2. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Detach the 2 claws to remove the lower steering column cover.
| 3. INSPECT TILT MOTOR |
![]() |
Apply the 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.
| Measurement Condition | Specified Condition |
| 12 V battery positive (+) lead → Terminal J48-2 (TIM+) 12 V battery negative (-) lead → Terminal J48-1 (TIM-) | The steering wheel tilts up. |
| 12 V battery positive (+) lead → Terminal J48-1 (TIM-) 12 V battery negative (-) lead → Terminal J48-2 (TIM+) | The steering wheel tilts down. |
| 4. INSPECT TELESCOPIC MOTOR |
![]() |
Disconnect connector A from the multiplex tilt and telescopic ECU.
Apply 12 V battery voltage to the multiplex tilt and telescopic ECU connector. Then check the steering wheel telescopic operation.
| Measurement Condition | Specified Condition |
| 12 V battery positive (+) lead → Terminal A-2 (TEM+) 12 V battery negative (-) lead → Terminal A-6 (TEM-) | The steering column contracts. |
| 12 V battery positive (+) lead → Terminal A-6 (TEM-) 12 V battery negative (-) lead → Terminal A-2 (TEM+) | The steering column extends. |
| 5. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the steering column lower cover.
| 6. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.
![]() |
Install the 2 screws.