Home › Drivetrain · A760F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > Pattern Select Switch Circuit

for Preparation Click here


DESCRIPTION

The ECM receives tow/haul pattern select switch information and performs tow/haul control.
While tow/haul control is operating, in contrast to normal mode, low gears are used to increase engine braking and towing power, reduce frequent shifts, and improve driveability. Tow/haul control includes throttle control, shift schedule control, wide open throttle shift timing control and AI-SHIFT control.
Tow/haul mode only operates when the shift lever is in D and the tow/haul pattern select switch is on.

HINT:
  1. The tow/haul pattern select switch is a momentary-type switch.
  2. In order to cancel tow/haul mode, push the tow/haul pattern select switch again or turn the ignition switch off.


WIRING DIAGRAM


C210348E01


INSPECTION PROCEDURE

1.INSPECT TOW/HAUL PATTERN SELECT SWITCH ASSEMBLY


    C210104E02
  1. Remove the tow/haul pattern select switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Tow/haul pattern select switch pushed
    Below 1 Ω
    Tow/haul pattern select switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Tow/Haul Pattern Select Switch)



NG
REPLACE TOW/HAUL PATTERN SELECT SWITCH ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - BODY GROUND)


    C210103E03
  1. Disconnect the H30 tow/haul pattern select switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H30-1 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Tow/Haul Pattern Select Switch)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - ECM)


    C197708E28
  1. Disconnect the A27 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A27-51 (PWR) - Body ground
    Tow/haul pattern select switch pushed
    Below 1 Ω
    Tow/haul pattern select switch not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)