AUTOMATIC TRANSMISSION SYSTEM > Pattern Select Switch Circuit |

| 1.INSPECT TOW/HAUL PATTERN SELECT SWITCH ASSEMBLY |
![]() |
Remove the tow/haul pattern select switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 4 | Tow/haul pattern select switch ON | Below 1 Ω |
| Tow/haul pattern select switch OFF | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - BODY GROUND) |
![]() |
Disconnect the H30 tow/haul pattern select switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H30-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TOW/HAUL PATTERN SELECT SWITCH - ECM) |
![]() |
Disconnect the A27 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A27-51 (PWR) - Body ground | Tow/haul pattern select switch ON | Below 1 Ω |
| Tow/haul pattern select switch OFF | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||