Home › Engine / Hybrid System ยท 3UR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.



    A163995E01
  1. Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.

    SST
    09223-22010  
    09506-35010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.



2. INSTALL CRANKSHAFT TIMING GEAR KEY


    A163993
  1. Install the crankshaft timing gear key.



3. INSTALL CRANKSHAFT PULLEY
  1. Align the pulley set key with the key groove of the pulley, and slide on the pulley.



    A164230E01
  1. Using SST, install the pulley set bolt.

    SST
    09213-70011  
    09330-00021  

    Torque:
    300 N*m{ 3059 kgf*cm , 221 ft.*lbf }



4. INSTALL FRONT STABILIZER BAR


    A163793
  1. Install the stabilizer bar and 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.

    Torque:
    69 N*m{ 704 kgf*cm , 51 ft.*lbf }



5. INSTALL RADIATOR ASSEMBLY
  1. Install the radiator assembly (Click here).



6. INSPECT FOR OIL LEAK