Home › Engine / Hybrid System ยท 1UR-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A215422
  1. Disconnect the MAF meter connector and clamp.

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



3. REMOVE CAMSHAFT POSITION SENSOR


A158617
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



4. REMOVE VVT SENSOR


A215432E01
  1. Disconnect the 4 sensor connectors.

  1. Remove the 4 bolts and 4 sensors.