Home › Engine / Hybrid System ยท 3UR-FE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector and 2 clamps.



    A184985
  1. Remove the 2 bolts and 2 nuts from the center exhaust pipe assembly.

  1. Remove the 3 nuts, 2 gaskets and front No. 2 exhaust pipe sub-assembly.



2. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector and 2 clamps.



    A184982
  1. Remove the 2 bolts from the center exhaust pipe.

  1. Remove the 3 nuts, front exhaust pipe and 2 gaskets.



3. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A194684E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A194684E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010