AIR FUEL RATIO SENSOR > REMOVAL |
| 1. REMOVE TAILPIPE ASSEMBLY |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the exhaust pipe support.
| 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
![]() |
Remove the 4 bolts.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the center exhaust pipe from the front exhaust pipe and front No. 2 exhaust pipe.
Remove the 2 gaskets from the front exhaust pipes.
| 3. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the heated oxygen sensor connector and 2 clamps.
Disconnect the air fuel ratio sensor connector.
![]() |
Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.
| 4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, remove the sensor.
| 5. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Remove the 2 bolts and heat insulator from the heat insulator bracket.
| 6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for 4WD) |
Disconnect the heated oxygen sensor connector.
Disconnect the air fuel ratio sensor connector.
Disconnect the front No. 2 exhaust pipe from the exhaust pipe support.
![]() |
Remove the 3 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.
| 7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
for 2WD:
Disconnect the air fuel ratio sensor connector.
![]() |
Using SST, remove the sensor.