Home › Engine / Hybrid System ยท 1UR-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe.
  3. The exhaust pipe is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)


    C158452
  1. Remove the 2 bolts and heat insulator from the heat insulator bracket.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector.



    A215444E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A215447E01
  1. Disconnect the heated oxygen sensor connector and 2 clamps.

  1. Using SST, remove the sensor.

    SST
    09224-00010