Home › Engine / Hybrid System · 1UR-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK HEATED OXYGEN SENSOR
  1. Disconnect the heated oxygen sensor connector.



    A159234E06
  1. Measure the heater resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HT1B) - 2 (+B)
    (for Bank 1)
    20°C (68°F)
    11 to 16 Ω
    1 (HT2B) - 2 (+B)
    (for Bank 2)

    If the result is not as specified, replace the heated oxygen sensor.

  1. Connect the heated oxygen sensor connector.