Home › Engine / Hybrid System ยท 1UR-FE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE AIR CLEANER ASSEMBLY


    A215422
  1. Disconnect the MAF meter connector and clamp.

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



3. DISCONNECT WATER PIPE ASSEMBLY


    A218002
  1. Remove the 2 nuts and disconnect the water pipe.



4. DISCONNECT CONNECTOR HOLDER BLOCK
  1. Remove the connector holder block cover.



    A215430
  1. Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.



5. REMOVE ECM


    A215595
  1. Disconnect the wire harness clamp.



    A218998E01
  1. Raise the 2 levers while pushing the locks on the 2 levers shown in the illustration.

    NOTICE:
    Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

  1. Disconnect the 2 connectors.



    A155993
  1. Remove the 4 bolts and ECM.



6. REMOVE GASKET


    A198571
  1. Peel off the rubber part of the gasket.



    A198572E01
  1. Spray gasket remover or equivalent on the remaining tape of the gasket.

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connector with a cloth.



    A198573
  1. Remove the tape of the gasket without using bladed objects.