Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY

REAR NO. 1 SEAT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below are for the RH side.



1. REMOVE REAR SEAT CUSHION HINGE COVER LOWER RH


B191794
  1. Disengage the 2 clips and 5 claws, and remove the rear seat cushion hinge lower cover.



2. REMOVE REAR FLOOR STEP NO. 1 COVER


B191403E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



3. REMOVE REAR FLOOR STEP NO. 2 COVER


B193052E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



4. REMOVE REAR DOOR SCUFF PLATE RH


B186665
  1. Remove the bolt.

  1. Disengage the 5 clips and the 6 claws and 2 guides, and remove the rear door scuff plate front side.



    B186666
  1. Remove the 2 bolts.

  1. Disengage the 5 clips and 2 claws, and remove the scuff plate rear side.



5. REMOVE REAR SEAT TRACK BRACKET COVER OUTER
  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B191075
  1. Detach the 2 claws and remove the seat track bracket cover.



6. REMOVE REAR SEAT TRACK BRACKET COVER INNER


    B195211
  1. Detach the 2 claws and remove the seat track bracket cover.



7. REMOVE SEAT TRACK BRACKET COVER INNER


B191077
  1. Operate the seat track adjusting handle to move the seat to the foremost position.

  1. Detach the 6 clips and remove the seat track bracket cover.



8. REMOVE SEAT TRACK BRACKET COVER INNER (w/ Center Seat)


B191076
  1. Operate the seat track adjusting handle to move the seat to the foremost position.

  1. Detach the 9 clips and remove the seat track bracket cover.



9. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    B191080
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B191079
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the center position.

  1. Remove the rear No. 1 seat assembly from the vehicle.

    NOTICE:
    Do not damage the vehicle body.



10. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (w/ Seat Heater System)


    B191078
  1. Disconnect the seat heater connector and detach the wire harness clamp.



    B191080
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B191079
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the center position.

  1. Remove the rear No. 1 seat from the vehicle.

    NOTICE:
    Do not damage the vehicle body.