Home › Audio/Visual/Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER

REAR DOOR SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR DOOR FRAME GARNISH RH


    B190577
  1. Disengage the 6 clips and remove the rear door frame garnish.



2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH


    B190575
  1. Using a moulding remover, disengage the 4 claws and remove the rear door inside handle bezel plug.



3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL RH


    B190574
  1. Disengage the 2 clips and 5 claws and remove the rear door armrest base upper panel.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH


B190578
  1. Remove the rear door armrest cover.

  1. Remove the 2 screws.



    B190579
  1. Disengage the 9 clips.

  1. Disconnect the connector.



    B190580
  1. Disconnect the rear door lock remote control cable and the rear door inside locking cable and remove the rear door trim board sub-assembly.



5. REMOVE REAR NO. 1 SPEAKER ASSEMBLY


    E161073
  1. Disconnect the speaker connector.

  1. Remove the 3 screws.



    E161077
  1. Disengage the 2 claws and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)


B191807
  1. Disengage the 3 claws and remove the speaker.