Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT BUMPER GARNISH
  1. Remove the 6 clips.



  1. Detach the 17 claws and remove the front bumper garnish.


    B228054E01



2. REMOVE FOG LIGHT COVER LH


    B194122
  1. Detach the 6 claws and remove the fog light cover.



3. REMOVE FOG LIGHT COVER RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light)


    E161818
  1. Remove the 3 bolts and the fog light mounting bracket.



5. REMOVE FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.



6. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


    E161819
  1. Disengage the 2 claws and remove the fog light.



7. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.



8. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)
  1. Disconnect the connector.



    E134853
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to removing the sensor.



9. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146464
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the front bumper.



10. REMOVE FRONT FENDER LINER BRACKET LH


    B194119
  1. Detach the 2 claws and remove the front fender liner bracket.



11. REMOVE FRONT FENDER LINER BRACKET RH

HINT:
Use the same procedure described for the LH side.



12. REMOVE CLIP


    B194123
  1. Remove the clip.

    HINT:
    Use the same procedure for all clips.



13. REMOVE FRONT BUMPER SIDE SUPPORT LH


    B194115
  1. Remove the 2 screws.

  1. Detach the 3 claws and remove the front bumper side support.



14. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.



15. REMOVE FRONT UPPER CENTER BUMPER RETAINER


    B194116
  1. Remove the 6 nuts and front upper center bumper retainer.



16. REMOVE FRONT BUMPER END RETAINER LH


    B194117
  1. Remove the 3 nuts and front bumper end retainer.



17. REMOVE FRONT BUMPER END RETAINER RH

HINT:
Use the same procedure described for the LH side.



18. REMOVE LASER RADAR SENSOR (w/ Dynamic Laser Cruise Control System)


E141176
  1. Disconnect the connector.

  1. Remove the 3 nuts and the laser radar sensor.



19. REMOVE FRONT BUMPER REINFORCEMENT


    B194118
  1. Remove the 6 nuts and front bumper reinforcement.



20. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH


  1. Remove the 4 nuts and front No. 2 bumper extension.

    HINT:
    The front No. 2 bumper extension cannot be removed easily if the stud bolts on the back side are installed to the body.

    B228055E01



21. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



22. REMOVE RADIATOR SIDE DEFLECTOR LH


    A215584
  1. Remove the 6 clips and side deflector.

  1. Disconnect the wire harness clamp.



23. REMOVE RADIATOR SIDE DEFLECTOR RH


    A232101E01
  1. Remove the 6 clips and side deflector.