REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the U2 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U2-12 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| U2-16 (+B) - Body ground | Always | 11 to 14 V |
| U2-15 (ACC) - Body ground | Ignition switch ACC |
|
| ||||
| OK | ||
| ||