REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Video Terminal and Television Display |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - VIDEO TERMINAL) |
![]() |
Disconnect the U2 television display assembly connector.
Disconnect the S5 video terminal connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U2-24 (ADPG) - S5-8 (ADPG) | Always | Below 1 Ω |
| U2-7 (R1+) - S5-2 (VAL+) | ||
| U2-8 (L1+) - S5-1 (VAR+) | ||
| U2-23 (SGND) - S5-3 (VA-) | ||
| U2-24 (ADPG) - Body ground | Always | 10 kΩ or higher |
| U2-7 (R1+) - Body ground | ||
| U2-8 (L1+) - Body ground | ||
| U2-23 (SGND) - Body ground |
|
| ||||
| OK | |
| 2.CHECK VIDEO (VIDEO ADAPTER) TERMINAL |
![]() |
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.
| Tester Connection | Condition | Specified Condition |
| S5-1 (VAR+) - Body ground | External device is playing, sound is being produced | Waveform synchronized with sound is output |
| S5-2 (VAL+) - Body ground |
|
| ||||
| OK | ||
| ||