REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - NAVIGATION RECEIVER) |
![]() |
Disconnect the U2 television display assembly connector.
Disconnect the I35 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U2-11 (NTSC) - I35-2 (VV+) | Always | Below 1 Ω |
| U2-10 (SGN1) - I35-6 (VV-) | ||
| U2-9 (SLD) - I35-6 (VV-) | ||
| U2-11 (NTSC) - Body ground | Always | 10 kΩ or higher |
| U2-10 (SGN1) - Body ground |
|
| ||||
| OK | |
| 2.CHECK TELEVISION DISPLAY ASSEMBLY (NTSC SIGNAL) |
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Terminal No. (Symbol) | U2-11 (NTSC) - Body ground |
| Tool Setting | 200 mV/DIV., 10 μs/DIV. |
| Condition | DVD displayed on television display |
|
| ||||
| OK | ||
| ||