Home › Vehicle Exterior › HORN › INTEGRATION RELAY

INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION NO.1 RELAY (Built in horn relay)


    B114449E01
  1. Check the resistance of the horn relay.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      A8 - T6
      When battery voltage is not applied
      10 kΩ or higher
      A8 - T6
      When battery voltage is applied to terminal A7 and T6
      Below 1 Ω

      If the result is not as specified, replace the integration relay.