POWER BACK DOOR SYSTEM > Power Back Door cannot be Closed Using the Power Back Door Closer Switch |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Back Door / Data List /
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PBD Close SW | Power back door closer switch signal / ON or OFF | ON: Power back door closer switch ON OFF: Power back door closer switch OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT POWER BACK DOOR CLOSER SWITCH |
![]() |
Remove the power back door closer switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 5 - 8 | Pushed (ON) | Below 1 Ω |
| 5 - 8 | Free (OFF) | 10 kΩ or higher |
Reinstall the power back door closer switch.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CLOSER SWITCH - DOOR DRIVE UNIT AND BODY GROUND) |
![]() |
Disconnect the O32 switch connector.
Disconnect the O30 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O32-8 (DS1) - O30-4 (DS1) | Always | Below 1 Ω |
| O32-5 (E) - Body ground | Always | Below 1 Ω |
| O32-8 (DS1) - Body ground | Always | 10 kΩ or higher |
Reconnect the switch connector.
Reconnect the ECU connector.
|
| ||||
| OK | ||
| ||