Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical or Power train / (desired system) / Data List.

  5. According to the display on the Techstream, read the Data List.

    Mirror 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Side SET Mem SW
    Driver side seat memory SET switch / ON or OFF
    ON: Driver side seat memory SET switch on
    OFF: Driver side seat memory SET switch off
    -
    Driver Side Memory SW 1
    Driver side seat memory switch 1 / ON or OFF
    ON: Driver side seat memory switch 1 on
    OFF: Driver side seat memory switch 1 off
    -
    Driver Side Memory SW 2
    Driver side seat memory switch 2 / ON or OFF
    ON: Driver side seat memory switch 2 on
    OFF: Driver side seat memory switch 2 off
    -

    Driver Seat 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Reclining Rear
    Reclining switch signal (Rearward) / ON or OFF
    ON: Reclining switch (Rearward) on
    OFF: Reclining switch (Rearward) off
    -
    Reclining Front
    Reclining switch signal (Forward) / ON or OFF
    ON: Reclining switch (Forward) on
    OFF: Reclining switch (Forward) off
    -
    Front Vertical Down
    Front vertical switch signal (Downward) / ON or OFF
    ON: Front vertical switch (Downward) on
    OFF: Front vertical switch (Downward) off
    -
    Front Vertical Up
    Front vertical switch signal (Upward) / ON or OFF
    ON: Front vertical switch (Upward) on
    OFF: Front vertical switch (Upward) off
    -
    Lifter Switch Down
    Lifter switch signal (Downward) / ON or OFF
    ON: Lifter switch (Downward) on
    OFF: Lifter switch (Downward) off
    -
    Lifter Switch Up
    Lifter switch signal (Upward) / ON or OFF
    ON: Lifter switch (Upward) on
    OFF: Lifter switch (Upward) off
    -
    Slide Rear
    Sliding switch signal (Rearward) / ON or OFF
    ON: Sliding switch (Rearward) on
    OFF: Sliding switch (Rearward) off
    -
    Slide Front
    Sliding switch signal (Forward) / ON or OFF
    ON: Sliding switch (Forward) on
    OFF: Sliding switch (Forward) off
    -
    SET Switch
    Seat memory SET switch signal / ON or OFF
    ON: Seat memory SET switch on
    OFF: Seat memory SET switch off
    -
    M1 Switch
    Seat memory switch 1 signal / ON or OFF
    ON: Seat memory switch 1 on
    OFF: Seat memory switch 1 off
    -
    M2 Switch
    Seat memory switch 2 signal / ON or OFF
    ON: Seat memory switch 2 on
    OFF: Seat memory switch 2 off
    -
    M3 Switch
    -
    -
    -
    Seat Memory No1
    Seat position memorized with seat memory switch 1 / Mem or Not Mem
    Mem: Memorized
    Not Mem: Not memorized
    -
    Seat Memory No2
    Seat position memorized with seat memory switch 2 / Mem or Not Mem
    Mem: Memorized
    Not Mem: Not memorized
    -
    Seat Memory No3
    -
    -
    -
    Ignition Switch
    Ignition switch signal / ON or OFF
    ON: Ignition switch ON signal received
    OFF: Ignition switch off signal received
    -
    Key Switch
    Ignition switch status / ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    Key Code Confirm
    -
    -
    -
    D-Door Courtesy
    Door courtesy switch signal / ON or OFF
    ON: Driver side door open
    OFF: Driver side door closed
    -
    P Switch
    Shift lever position P signal / ON or OFF
    ON: Shift lever in P
    OFF: Shift lever not in P
    -
    Parking Brake SW
    Parking brake switch status / ON or OFF
    ON: Parking brake operated
    OFF: Parking brake released
    -
    Vehicle Speed
    Vehicle speed data / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Actual vehicle speed
    -
    Power Voltage
    Power supply for driver seat ECU / MIN: 0 V, MAX: 19.89 V
    Within range from 11 V to 14 V
    -
    Slide Position
    Seat sliding position / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Reclining Position
    Seatback position / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Front Vertical Position
    Seat front vertical position / MIN: 4096 MAX: 61440
    Within range from 4096 to 61440
    -
    Lifter Position
    Seat lifter position / MIN: 4096 MAX: 61440
    Within range from 4096 to 61440
    -
    Slide Pos Mem No1
    Seat sliding position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Reclining Pos Mem No1
    Seatback position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Frnt Vrtcl Pos Mem No1
    Front vertical position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Lifter Pos Mem No1
    Lifter position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Slide Pos Mem No2
    Seat sliding position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Reclining Pos Mem No2
    Seatback position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Frnt Vrtcl Pos Mem No2
    Front vertical position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Lifter Pos Mem No2
    Lifter position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440
    Within range from 4096 to 61440
    -
    Slide Pos Mem No3
    -
    -
    -
    Reclining Pos Mem No3
    -
    -
    -
    Frnt Vrtcl Pos Mem No3
    -
    -
    -
    Lifter Pos Mem No3
    -
    -
    -

    ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift SW Status (P Range)
    PNP switch status / ON or OFF
    ON: Shift lever in P
    OFF: Shift lever not in P
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical / Driver Seat / Active Test.

  5. According to the display on the Techstream, perform the Active Test.

    Driver Seat 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Seat Reclining
    Seat reclining operation
    Front/OFF/Rear
    -
    Front Vertical Operation
    Seat front vertical operation
    Up/OFF/Down
    -
    Lifter Operation
    Seat lifter operation
    Up/OFF/Down
    -
    Seat Slide Operation
    Seat sliding operation
    Front/OFF/Rear
    -
    Buzzer
    Buzzer operation
    ON/OFF
    -