Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR

FRONT ACCELERATION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ACCELERATION SENSOR ASSEMBLY


C179517E02
  1. Inspect the acceleration sensor LH.

  1. Connect 3 dry cell batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 3 (SGV) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SGND). Then measure the voltage between terminal 1 (SGRR) and terminal 2 (SGND).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Sensor Condition
    Specified Condition
    1 (SGRR) - 2 (SGND)
    Sensor stationary
    Approx. 2.0 to 2.5 V
    Sensor is tilted
    Change between approx. 0.9 to 2.3 V

    NOTICE:
    Do not apply a voltage of more than 6 V.

    HINT:
    When the acceleration sensor is tilted, it may output a different value.



    C179517E01
  1. Inspect the acceleration sensor RH.

  1. Connect 3 dry cell batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SHG). Then measure the voltage between terminal 1 (SGFL) and terminal 2 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Sensor Condition
    Specified Condition
    1 (SGFL) - 2 (SHG)
    Sensor stationary
    Approx. 2.0 to 2.5 V
    Sensor is tilted
    Change between approx. 0.9 to 2.3 V

    NOTICE:
    Do not apply a voltage of more than 6 V.

    HINT:
    When the acceleration sensor is tilted, it may output a different value.