FRONT ACCELERATION SENSOR > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
| 2. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Detach the 9 claws and remove the scuff plate.
| 3. REMOVE COWL SIDE TRIM BOARD LH |
| 4. REMOVE COWL SIDE TRIM BOARD RH |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board.
| 5. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 6. REMOVE INSTRUMENT SIDE PANEL RH |
![]() |
Using a moulding remover, detach the 6 claws and remove the side panel.
| 7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 9. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 10. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Detach the clip and 4 claws.
Detach the 2 guides and remove the under cover.
| 11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH |
![]() |
Remove the bolt <A> and 3 <D> screws.
Detach the 3 claws and remove the finish panel.
![]() |
Disconnect the connector.
| 12. REMOVE ACCELERATION SENSOR ASSEMBLY (for LH Side) |
![]() |
Disconnect the acceleration sensor connector.
Remove the nut and the acceleration sensor.
| 13. REMOVE ACCELERATION SENSOR ASSEMBLY (for RH Side) |
![]() |
Disconnect the acceleration sensor connector.
Remove the nut and the acceleration sensor.