Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL SWITCH

ABSORBER CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SUSPENSION CONTROL SWITCH


C179525E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (ECU1) - 7 (GND)
    SPORT position
    Below 1 Ω
    Normal position
    10 kΩ or higher
    8 (ECU2) - 7 (GND)
    COMFORT position
    Below 1 Ω
    Normal position
    10 kΩ or higher