Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


C179494E02
  1. Inspect the rear height control sensor sub-assembly LH.

  1. Connect 3 dry cell batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 1 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Sensor Condition
    Specified Condition
    2 (SHRL) - 1 (SHG)
    High (45°)
    4.4 to 4.6 V
    Normal (0°)
    2.3 to 2.6 V
    Low (-45°)
    0.4 to 0.6 V

    NOTICE:
    Do not apply a voltage of more than 6 V.



    C179494E01
  1. Inspect the rear height control sensor sub-assembly RH.

  1. Connect 3 dry cell batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Sensor Condition
    Specified Condition
    2 (SHRR) - 1 (SHG)
    High (45°)
    4.4 to 4.6 V
    Normal (0°)
    2.3 to 2.6 V
    Low (-45°)
    0.4 to 0.6 V

    NOTICE:
    Do not apply a voltage of more than 6 V.