REAR SHOCK ABSORBER > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FE) |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe assembly from the exhaust pipe support.
| 3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FBE) |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe assembly from the exhaust pipe support.
| 4. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 1UR-FE) |
![]() |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the exhaust pipe support.
| 5. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD) |
| 6. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Remove the 2 bolts and propeller shaft heat insulator.
| 7. REMOVE TRANSFER HEAT INSULATOR (for 4WD) |
![]() |
Remove the 3 bolts and transfer heat insulator.
| 8. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 8 nuts and then remove the propeller shaft assembly.
| 9. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension) |
![]() |
Put matchmarks on the rear height control sensor link and bracket.
Remove the nut and disconnect the rear height control sensor link.
![]() |
Disconnect the rear height control sensor connector.
Remove the nut and the rear height control sensor.
| 10. REMOVE REAR STABILIZER BAR |
| 11. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/o Air Suspension) |
![]() |
Remove the 2 bolts and nut and remove the rear shock absorber.
| 12. REMOVE REAR SHOCK ABSORBER ASSEMBLY (w/ Air Suspension) |
![]() |
Disconnect the AVS connector.
![]() |
Remove the 2 bolts and nut and remove the rear shock absorber.