OIL COOLER > INSTALLATION |
| 1. INSTALL TRANSMISSION OIL COOLER ASSEMBLY (w/o Trailer Towing System) |
![]() |
Coat 4 new O-rings with ATF.
Install the 4 O-rings, transmission oil cooler spacer and transmission oil cooler to the automatic transmission.
Temporarily install the bolt A.
Install the 2 bolts B and tighten them to the specified torque. Then tighten bolt A to the specified torque.
| 2. INSTALL TRANSMISSION OIL COOLER ASSEMBLY (w/ Trailer Towing System) |
![]() |
Coat 4 new O-rings with ATF.
Install the 4 O-rings, transmission oil cooler thermostat and transmission oil cooler to the automatic transmission.
Temporarily install the bolt A.
Install the 2 bolts B and tighten them to the specified torque. Then tighten bolt A to the specified torque.
![]() |
Connect the 2 No. 2 transmission oil cooler hoses to the transmission oil thermostat.
| 3. CONNECT WATER BY-PASS PIPE ASSEMBLY |
![]() |
Connect the 2 water by-pass hoses with the 2 clips and install the water by-pass pipe with the bolt.
| 4. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 3 new nuts.
Connect the air fuel ratio sensor connector.
| 5. ADD ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 6. ADJUST AUTOMATIC TRANSMISSION FLUID |
Adjust automatic transmission fluid (Click here).
| 7. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |
| 8. INSPECT FOR ENGINE COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 9. INSPECT FOR EXHAUST GAS LEAK |