Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU

POWER STEERING ECU > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING ECU ASSEMBLY


C181335
  1. Install the power steering ECU with the nut.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the power steering ECU connector.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and attach the wire harness clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Connect the connectors.

  1. Attach the 4 clips and 2 claws to install the finish panel.



5. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



6. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



7. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.