Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > INSPECTION

for Preparation Click here




1. INSPECT VISOR ASSEMBLY LH


    E160702E01
  1. Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

  1. Check that the vanity light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+)
    → Terminal 2
    Battery negative (-)
    → Terminal 1
    A
    Vanity light comes on
    B to A
    Vanity light gradually becomes brighter
    B
    Vanity light turns off

    If the result is not as specified, replace the visor assembly LH.



2. INSPECT VISOR ASSEMBLY RH


    E160768E01
  1. Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

  1. Check that the vanity light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+)
    → Terminal 2
    Battery negative (-)
    → Terminal 1
    A
    Vanity light comes on
    B to A
    Vanity light gradually becomes brighter
    B
    Vanity light turns off

    If the result is not as specified, replace the visor assembly RH.