Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.



1. REMOVE VISOR BRACKET COVER RH


B190134E01
  1. Using a moulding remover B with its tip wrapped in protective tape, disengage the 4 claws and remove the visor bracket cover.



2. REMOVE VISOR ASSEMBLY RH


    B190133
  1. Remove the 4 screws and visor.