Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL INTERIOR DOME LIGHT SWITCH ASSEMBLY


    E161810
  1. Engage the 2 claws and install the interior dome light switch.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and attach the wire harness clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side .



5. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .