Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



3. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side .



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Detach the 4 claws and remove the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and detach the wire harness clamp.

  1. Detach the 12 clips and remove the finish panel.



6. REMOVE INTERIOR DOME LIGHT SWITCH ASSEMBLY


    E161810
  1. Disengage the 2 claws and remove the interior dome light switch.