Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    E161854E01
  1. Disconnect the connector from the rear combination light.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Switch Condition
    Specified Condition
    O21-2 - O21-1
    Light control switch OFF
    Below 1 Ω
    Light control switch in TAIL
    11 to 14 V
    O21-3 - O21-1
    Brake pedal released
    Below 1 Ω
    Brake pedal depressed
    11 to 14 V
    O23-1 - O23-2
    Turn signal switch OFF
    Below 1 Ω
    Ignition switch ON and Turn signal switch in LH
    11 to 14 V (60 to 120 times per minute)



2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    E161854E02
  1. Disconnect the connector from the rear combination light.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Switch Condition
    Specified Condition
    O20-2 - O20-1
    Light control switch OFF
    Below 1 Ω
    Light control switch in TAIL
    11 to 14 V
    O20-3 - O20-1
    Brake pedal released
    Below 1 Ω
    Brake pedal depressed
    11 to 14 V
    O22-1 - O22-2
    Turn signal switch OFF
    Below 1 Ω
    Ignition switch ON and turn signal switch in RH
    11 to 14 V (60 to 120 times per minute)