Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR CENTER GARNISH


    B190514
  1. Disengage the 4 clips and the claw and remove the back door center garnish.



2. REMOVE BACK DOOR SIDE GARNISH RH


    B190515
  1. Disengage the 2 clips and remove the back door side garnish RH.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B190516
  1. Disengage the 3 clips and remove the back door side garnish LH



4. REMOVE BACK DOOR STRAP COVER


    B190517
  1. Slide the back door strap cover and disengage the claw and remove the back door strap cover.



5. REMOVE BACK DOOR PULL STRAP


    B190519
  1. Remove the bolt and remove the back door pull strap.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B190520
  1. Disengage the 11 clips and remove the back door trim board assembly.



7. REMOVE BACK DOOR SERVICE HOLE COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



8. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


B191712
  1. Remove the 4 nuts.

  1. Disconnect the connector.



    B191713
  1. Disengage the 2 clips and remove the back door outside garnish.



9. REMOVE REAR TELEVISION CAMERA ASSEMBLY


    E192391
  1. Disconnect the connector.



    E192392
  1. Disengage the 2 claws and remove the rear television camera.



10. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    E161800
  1. Remove the 4 screws.

  1. Disconnect the 4 harness clamps and remove the license plate light.



11. REMOVE LICENSE PLATE LIGHT BULB
  1. Remove the license plate light bulb from the light socket.