Home › Vehicle Exterior › LIGHTING (EXT) › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER RELAY


    E109076E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage not applied
      10 kΩ or higher
      3 - 5
      When battery voltage to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer relay.



2. INSPECT HEADLIGHT RELAY


    E109076E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage not applied
      10 kΩ or higher
      3 - 5
      When battery voltage to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the headlight relay.



3. INSPECT FOG LIGHT RELAY


    E109078E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage not applied
      10 kΩ or higher
      3 - 5
      Apply battery voltage to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the fog light relay.



4. INSPECT TOWING TAIL RELAY


    E109078E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage not applied
      10 kΩ or higher
      3 - 5
      Apply battery voltage to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the towing tail relay.