Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE REFLEX REFLECTOR ASSEMBLY LH


B191657
  1. Remove the nut and reflex reflector.



2. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER LOWER COVER (w/o Towing Hitch)


B191662E01
  1. Remove the rear bumper lower cover.

    NOTICE:
    Remove any tape remaining on the cover side.



4. REMOVE REAR BUMPER LOWER COVER (w/ Towing Hitch)


B191658E01
  1. Remove the rear bumper lower cover.

    NOTICE:
    Remove any tape remaining on the cover side.



5. REMOVE GROMMET


B191661E01
  1. Remove the 6 grommets.



6. REMOVE NO. 2 FRAME WIRE (w/ Intuitive Parking Assist System)


B191663
  1. Disconnect the 4 connectors.

  1. Disconnect the 6 clamps and No. 2 frame wire.



7. REMOVE NO. 1 ULTRASONIC SENSOR
  1. Disconnect the sensor connector.



    E146470
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The types of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.



8. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E146469
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.



9. REMOVE NO. 2 ULTRASONIC SENSOR
  1. Disconnect the sensor connector.



    E146468
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The types of claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting removing the sensor.



10. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    E146469
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.



11. REMOVE REAR BUMPER UPPER RETAINER LH


B191664
  1. Remove the 3 screws.

  1. Disengage the 4 claws and remove the rear bumper upper retainer.



12. REMOVE REAR BUMPER UPPER RETAINER RH

HINT:
Use the same procedure as for the LH side.



13. REMOVE REAR BUMPER END RETAINER LH


B191665
  1. Remove the screw.

  1. Disengage the 2 claws and remove the rear bumper end retainer.



14. REMOVE REAR BUMPER END RETAINER RH

HINT:
Use the same procedure as for the LH side.



15. REMOVE REAR BUMPER ENERGY ABSORBER


B191666
  1. Remove the rear bumper energy absorber.



16. REMOVE REAR FLOOR STAY BRACKET LH


B191667
  1. Remove the 2 bolts and rear floor stay bracket.



17. REMOVE REAR FLOOR STAY BRACKET RH

HINT:
Use the same procedure as for the LH side.



18. REMOVE REAR BUMPER ARM BRACKET LH


B191668
  1. Remove the 2 bolts and rear bumper arm brackets.



19. REMOVE REAR BUMPER ARM BRACKET RH

HINT:
Use the same procedure as for the LH side.



20. REMOVE REAR BUMPER BAR BRACKET LH


B191669
  1. Remove the bolt and rear bumper bar bracket.



21. REMOVE REAR BUMPER BAR BRACKET RH

HINT:
Use the same procedure as for the LH side.