Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP


B191705
  1. Engage the 5 claws and clip and install a new rear door glass outer weatherstrip.



2. INSTALL REAR DOOR WINDOW FRAME REAR MOULDING

HINT:
When installing the rear door window frame rear moulding, heat the vehicle body and rear door window frame rear moulding using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Door Window Frame Rear Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or rear door window frame rear moulding excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B256636E01
  1. Install a new rear door window frame rear moulding.

    1. Using a heat light, heat a new rear door window frame rear moulding and the vehicle body surface.

    2. Remove the peeling paper from the face of the rear door window frame rear moulding.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Attach the 2 clips and double-sided tape to install the rear door window frame rear moulding.

      HINT:
      When installing the rear door window frame rear moulding, be sure to press the area attached with the double-sided tape with sufficient force {30 N (3 kgf, 6.7 lbf) or more}.