Home › Vehicle Exterior › WINDOW / GLASS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT WIPER DEICER RELAY


    E109078E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage not applied
      10 kΩ or higher
      3 - 5
      Apply battery voltage to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the front wiper deicer relay.



2. INSPECT DEFOGGER RELAY


    E106620E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      When battery voltage is not applied
      Below 1 Ω
      3 - 4
      When battery voltage applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      When battery voltage is not applied
      10 kΩ or higher
      3 - 5
      When battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the defogger relay.