Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)

REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side) > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH


    B193994
  1. Remove the 2 clips.



    B193995
  1. Remove the bolt and rear No. 2 seat inner belt assembly.



2. REMOVE REAR SEAT LOCK COVER OUTER LH


    B193996
  1. Remove the screw.

  1. Detach the 2 claws and remove the rear seat lock cover outer LH.



3. REMOVE REAR SEAT LOCK COVER INNER RH


    B193998
  1. Remove the screw.

  1. Detach the 3 claws and remove the rear seat lock cover inner RH.



4. REMOVE REAR NO. 2 SEAT CUSHION ASSEMBLY LH


    B194000
  1. Remove the 2 bolts.

  1. Using a T45 "TORX" socket wrench, remove the 2 "TORX" bolts and 2 bushes. Then remove the rear No. 2 seat cushion assembly LH.



5. REMOVE NO. 3 SEAT CUSHION SPRING ASSEMBLY LH


    B194001
  1. Remove the hog rings.



    B194003
  1. Detach the hooks and remove the No. 3 seat cushion spring assembly LH.



6. REMOVE NO. 2 SEAT CUSHION COVER SUB-ASSEMBLY LH


    B194004
  1. Remove the hog rings and No. 2 seat cushion cover sub-assembly LH from the No. 2 seat cushion pad.



7. REMOVE REAR SEAT CUSHION COVER LH


    B194006
  1. Remove the screw.

  1. Detach the claw and remove the rear seat cushion cover LH.



8. REMOVE REAR SEAT CUSHION COVER INNER RH


    B194007
  1. Remove the screw.

  1. Detach the claw and remove the rear seat cushion cover inner RH.



9. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
  1. Remove the rear center seat headrest assembly.



10. REMOVE REAR NO. 2 SEATBACK COVER LH


    B195227
  1. Detach the 3 claws and remove the rear No. 2 seatback cover LH.



11. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH


    B290081
  1. Detach the 12 clips and remove the rear seatback board sub-assembly LH.



12. REMOVE REAR SEAT HEADREST ASSEMBLY


B288835
  1. Detach the hook and disconnect the lower part of the No. 2 seatback cover sub-assembly LH.



    B288833E01
  1. Remove the cable clamp and disconnect the headrest cable from the No. 3 seatback frame sub-assembly LH.

  1. Detach the cable clamp, twist the cable end in the direction indicated by the arrow and disconnect the headrest cable from the reclining control base LH.



    B288883E01
  1. Using a screwdriver, push in the headrest lock button to release the headrest lock.

    HINT:
    Tape the screwdriver tip before use.

  1. Pull up and remove the rear seat headrest assembly.

    NOTICE:
    When removing the rear seat headrest assembly while it is in the vehicle, fold down the headrest before removing it so that it does not contact the roof.



13. REMOVE REAR NO. 2 SEAT HEADREST SUPPORT ASSEMBLY


    B290086
  1. Detach the 8 claws and remove the 4 rear No. 2 seat headrest supports.



14. REMOVE SEATBACK COVER WITH PAD


    B288985
  1. Detach the 2 wire harness clamps.

  1. Detach the hooks.



    B194019
  1. Remove the clip and rear seat belt hook.

  1. Remove the hog ring and seatback cover with pad.



15. REMOVE NO. 2 SEATBACK COVER SUB-ASSEMBLY LH


    B194022
  1. Remove the hog rings and No. 2 seatback cover sub-assembly LH from the No. 2 seatback pad.



16. REMOVE REAR NO. 2 SEAT WIRE LH


    B293205
  1. Disconnect the 3 connectors.

  1. Detach the 5 wire harness clamps and remove the rear No. 2 seat wire LH.



17. REMOVE RECLINING CONTROL BASE LH


    B194027
  1. Remove the 2 nuts and reclining control base LH.



18. REMOVE NO. 3 SEATBACK FRAME SUB-ASSEMBLY LH


    B293206
  1. Remove the 3 bolts and No. 3 seatback frame sub-assembly LH.



19. REMOVE POWER SEAT MOTOR ASSEMBLY RH


    B194029E01
  1. Using a screwdriver, remove the 2 washers.

    HINT:
    Tape the screwdriver tip before use.



    B201579
  1. Using a screwdriver and hammer, lightly tap the reclining connecting pipe to remove it.



    B191242
  1. Remove the 3 bolts and power seat motor assembly RH.



20. REMOVE POWER SEAT MOTOR ASSEMBLY LH


    B191243
  1. Remove the 3 bolts and power seat motor assembly LH.



21. REMOVE REAR NO. 2 SEAT ROD SUB-ASSEMBLY


    B194032
  1. Remove the 2 bolts and No. 2 seat rod sub-assembly.