Home › Vehicle Interior › SEAT › POWER SEAT CONTROL ECU (for LH Side)

POWER SEAT CONTROL ECU (for LH Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Manual Seat)
  1. Remove the rear No. 2 seat assembly LH (Click here).



2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Power Seat)
  1. Remove the rear No. 2 seat assembly LH (Click here).



3. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH

HINT:
Use the same procedure for both sides.



4. REMOVE REAR FLOOR STEP NO. 1 COVER


B191403E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



5. REMOVE REAR FLOOR STEP NO. 2 COVER


B193052E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



6. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure for both sides.



8. REMOVE ROPE HOOK ASSEMBLY


B190140E01

HINT:
Use the same procedure for both sides.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.



    B190141
  1. Remove the bolt and rope hook.



9. REMOVE REAR FLOOR MAT SUPPORT PLATE


B190142
  1. Disengage the 5 clips and 4 claws, and remove the rear floor mat support plate.



10. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Manual Seat)


B193920
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B191818
  1. Remove the bolt and outer lap belt anchor.



    B191816
  1. Remove the bolt and outer lap belt anchor.



    B191817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.

  1. Remove the 2 bolts and 2 clips.

  1. Disengage the 11 clips.



  1. Disconnect the connector and remove the quarter trim panel.


    B222458



11. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat)


B193920
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B191818
  1. Remove the bolt and outer lap belt anchor.



    B191816
  1. Remove the bolt and outer lap belt anchor.



    B191817E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.

  1. Remove the 2 bolts and 2 clips.

  1. Disengage the 2 clamps and remove the wire harness.

  1. Disengage the 11 clips and 2 clamps.



  1. Disconnect the 3 connectors and remove the quarter trim panel.


    B222460



12. REMOVE W/ BOX NO. 1 SPEAKER ASSEMBLY (for 14 Speakers)


    E161046
  1. Disconnect the connector.

  1. Remove the 4 bolts and the w/box No. 1 speaker.



13. REMOVE FOLD SEAT CONTROL ECU


    B194055
  1. Disconnect the 2 connectors.

  1. Remove the 2 bolts and fold seat control ECU.