Home › Vehicle Interior › SEAT › POWER SEAT CONTROL ECU (for RH Side)

POWER SEAT CONTROL ECU (for RH Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Manual Seat)
  1. Remove the rear No. 2 seat assembly RH (Click here).



2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Power Seat)
  1. Remove the rear No. 2 seat assembly RH (Click here).



3. REMOVE REAR SEAT CUSHION HINGE LOWER COVER RH


B191794
  1. Disengage the 2 clips and 5 claws, and remove the rear seat cushion hinge lower cover.



4. REMOVE REAR FLOOR STEP NO. 1 COVER


B191403E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



5. REMOVE REAR FLOOR STEP NO. 2 COVER


B193052E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



6. REMOVE REAR DOOR SCUFF PLATE RH


B186665
  1. Remove the bolt.

  1. Disengage the 5 clips and the 6 claws and 2 guides, and remove the rear door scuff plate front side.



    B186666
  1. Remove the 2 bolts.

  1. Disengage the 5 clips and 2 claws, and remove the scuff plate rear side.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


B191804
  1. Remove the rear door opening trim weatherstrip.



8. REMOVE ROPE HOOK ASSEMBLY


B190140E01

HINT:
Use the same procedure for both sides.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.



    B190141
  1. Remove the bolt and rope hook.



9. REMOVE REAR FLOOR MAT SUPPORT PLATE


B190142
  1. Disengage the 5 clips and 4 claws, and remove the rear floor mat support plate.



10. REMOVE QUARTER TRIM PANEL ASSEMBLY RH (for Manual Seat)


B190121E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the cover.



    B190124
  1. Remove the bolt.

  1. Detach the 5 clips.

  1. Pass the rear seat outer belt floor anchor through the rear window side garnish, and remove the rear window side garnish.



11. REMOVE QUARTER TRIM PANEL ASSEMBLY RH (for Power Seat)


B190145
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B190158
  1. Remove the bolt and outer lap belt anchor.



    B190146
  1. Remove the bolt and outer lap belt anchor.



    B190148E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cover.

  1. Remove the 2 bolts and 2 clips.

  1. Disengage the 11 clips.



  1. Disconnect the 3 connectors and remove the quarter trim panel.


    B222459



12. REMOVE FOLD SEAT CONTROL ECU


    B194058
  1. Disconnect the 2 connectors.

  1. Remove the 2 nuts and fold seat control ECU.