Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL DRIVE MONITOR SWITCH


E146525
  1. Attach the 2 claws to install the drive monitor switch.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and attach the wire harness clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL INSTRUMENT SIDE PANEL LH


    B231212
  1. Attach the 7 claws to install the side panel.



5. INSTALL COWL SIDE TRIM BOARD LH
  1. Attach the 2 clips to install the cowl side trim board.



    B231210
  1. Install the clip.



6. INSTALL FRONT DOOR SCUFF PLATE LH


    B231209
  1. Attach the 9 claws to install the front door scuff plate.