Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


    B231209
  1. Detach the 9 claws and remove the front door scuff plate.



2. REMOVE COWL SIDE TRIM BOARD LH
  1. Remove the clip.



    B231210
  1. Detach the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B231211
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B229064
  1. Remove the 2 bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL


B192334
  1. Detach the 4 claws and remove the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and detach the wire harness clamp.

  1. Detach the 12 clips and remove the finish panel.



6. REMOVE DRIVE MONITOR SWITCH


    E146525
  1. Detach the 2 claws and remove the drive monitor switch.