FUEL PRESSURE PULSATION DAMPER > INSTALLATION |
| 1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Apply a light coat of spindle oil or gasoline to the 2 O-rings.
![]() |
Install the 2 fuel pressure pulsation dampers to the fuel delivery pipes.
| 2. INSTALL FUEL PRESSURE PULSATION DAMPER COVER |
![]() |
Install the 2 fuel pressure pulsation damper covers with the 4 bolts.
| 3. INSTALL FUEL PRESSURE PULSATION DAMPER CAP |
![]() |
Install the 2 fuel pressure pulsation damper caps.
| 4. INSTALL NO. 3 ENGINE COVER |
![]() |
Install the No. 3 engine cover.
| 5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Install the No. 1 engine cover sub-assembly.
| 6. CONNECT NO. 3 VENTILATION HOSE |
![]() |
Connect the No. 6 wire harness connector.
Connect the No. 3 ventilation hose.
| 7. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose with the 2 clamps.
Connect the vacuum hose.
Connect the ventilation hose.
| 8. INSTALL V-BANK COVER |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.
| 9. INSPECT FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.