FUEL PRESSURE PULSATION DAMPER > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 4. DISCONNECT NO. 3 VENTILATION HOSE |
![]() |
Disconnect the No. 3 ventilation hose and No. 6 wire harness connector.
| 5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the No. 1 engine cover sub-assembly.
| 6. REMOVE NO. 3 ENGINE COVER |
![]() |
Remove the No. 3 engine cover.
| 7. REMOVE FUEL PRESSURE PULSATION DAMPER CAP |
![]() |
Remove the 2 fuel pressure pulsation damper caps.
| 8. REMOVE FUEL PRESSURE PULSATION DAMPER COVER |
![]() |
Remove the 4 bolts and 2 fuel pressure pulsation damper covers.
| 9. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Pull the 2 fuel pressure pulsation dampers out of the fuel delivery pipes to remove them.